Elite controllers can be quickly programmed without a computer; the JetiBox is all that is needed. Speed controllers have a Data Logging function that lets you check and fine tune the setup of your airplane or helicopter. Readings for Peak controller temperature, Maximum current, Minimum current, RPM, Motor run time and many other parameters are recorded and can be viewed right on the JetiBox after a flight. This allows you to make adjustments immediately and fly again to see the results. Get them here!

Rob’s M Testimonial: Esprit Elite 165HV ESC – Success with the XPWR 60!

I installed and programmed the ESC yesterday and snuck out for two flights in a 15mph crosswind. Unfortunately with the crosswind, I was out by myself so no video yet. I’m happy to say the ESC and motor played will together and the acceleration and ‘feel’ was fantastic. I put the plane in every orientation possible to try and induce a commutation error but the ESC pushed through every maneuver with zero hesitation. My first take on the settings worked great: high filtration, 25 degrees timing, 8khz sampling, 0.6sec acceleration).

This ESC also appears to be pushing through a little more power to the motor than the Hobbywing ESC that it replaced. Vertical acceleration was outstanding.

On a fresh set of packs, I pulled 6,779 watts / 145.7 amps / 44.86v min. Xoar PJN 24×12.

  • Esprit Elite 55SB 8S w/BEC $95.00
  • Esprit Elite 80SB 8S w/BEC $109.00
  • Esprit Elite 100SB 8S w/BEC $125.00
  • Esprit Elite 95HV 12S $195.00
  • Esprit Elite 125HV 12S $225.00
  • Esprit Elite 165HV 12S $265.00

One Reply to “Introducing Esprit Elite ESCs with Data Logging & Telemetry, In Stock!!!”

  1. I have an Elite 100 with an Esprit Elite FES E40/30-500 sailplane outrunner (Mare mfg.) Unfortunatley I have no user manual/documentation. Can you please send me a PDF?

    Also I will be using a JR radio. What if any additional products do you recommend for programming or telemetry?

    Cheer,
    Kurt Seiter

Leave a Reply

Your email address will not be published. Required fields are marked *